Turbo Technology

A turbocharger, or turbo, is a gas compressor that is used for forced-induction of an internal combustion engine. A form of supercharger, the turbocharger increases the density of air entering the engine to create more power. A turbocharger has the compressor powered by a turbine, driven by the engine's own exhaust gases, rather than direct mechanical drive as with many other superchargers.

A turbocharger is a small radial fan pump driven by the energy of the exhaust gases of an engine. A turbocharger consists of a turbine and a compressor on a shared shaft. The turbine converts exhaust heat and pressure to rotational force, which is in turn used to drive the compressor. The compressor draws in ambient air and pumps it in to the intake manifold at increased pressure, resulting in a greater mass of air entering the cylinders on each intake stroke.

The objective of a turbocharger is the same as a supercharger; to improve the engine's volumetric efficiency by solving one of its cardinal limitations. A naturally aspirated automobile engine uses only the downward stroke of a piston to create an area of low pressure in order to draw air into the cylinder through the intake valves. The pressure in the atmosphere is no more than 1 atm (approximately 14.7 psi), so there ultimately will be a limit to the pressure difference across the intake valves and thus the amount of airflow entering the combustion chamber. Since the turbocharger increases the pressure at the point where air is entering the cylinder, a greater mass of air (oxygen) will be forced in as the inlet manifold pressure increases. The additional air flow makes it possible to maintain the combustion chamber pressure and fuel/air load even at high engine revolution speeds, increasing the power and torque output of the engine. To avoid detonation and physical damage, the pressure in the cylinder must not go too high, to prevent this the intake pressure must be controlled by venting excess gas. The control function is performed by a wastegate, which routes some of the exhaust flow away from the turbine. This regulates air pressure in the intake manifold.